12/31/2022 0 Comments Aragon 8008x3 manual![]() ![]() Pre/Pro: Outlaw 990 running in balanced / single ended configuration Also, the 20.0 is bi-amped, I am considering tri-amped with stereo subs (quad amped), will be using the 2nd ICBM to split the very bottom again. I am thinking about STS cylinders, like the "ultra" in stereo it has a aluminum cone with kevlar spider. BTW, I understand magnapan is coming out with a new center speaker based on the 20.1 I think I will be taking one.Īs far as subs go, I am using the HSU VTF3 (series 1), it's pretty good. The CC3 has a different design in that the middle is flattened, to allow 80hz xover, but I prefer a full curved panel as in the cc2. Still, use the same sub stting as your mains in theis case. Of course you could plug in your rears into the ICBM as well, and that will shift some bass to the frount. Now the center isn't limited by it's lowend response, esentially you have triamped center, with the cc2 at the top, the mains as midbass, and sub as bottom. Of course set the mains and sides as normal (perhaps 60/80hz?). In your situation, I would use the 990 sub out to your sub, and set the center xover to whatever the MAINS are xovered at. What happens is the 200hz and below from the center gats split betweeen the mains signal out to my bass panels. I have a 3 way DEQX xover for my 20.0, and take the low end and drive it through the "mains" input, and hook the center input to the 990 center out, then the ICBM center out to my center amp. The CC2 is the best I have tried so far, the problem is the mid-bass 160hz (actually I xover at 200hz) is not a good place to send to your sub, it sounds awful if you try it like that I use the ICBM magnapan (which means the center channel xover is doubled, 100hz is really 200hz) in recombine mode. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |